Hyundai HBVE2800 Original Instructions Manual page 22

Insert the supplied wheel axle (A) through the respective openings of each tube.
4.3.2- Wheels (Fig.3)
Put the supplied washer (B) and sleeve (C) onto the wheel axle (A) (Fig. 3B)
Place the wheels (D) and tighten nut (E) by hand (Fig. 3C).
Using the supplied hex wrench (F), fix the wheel axle and at the same time firmly tighten the nut
by using a wrench (not supplied) (G). (Fig. 3D)
Finally, place the wheel cover (H) in the center of the wheel. (Fig. 3E)
Fig.2
Fig.3c
Turn the shredder back on its stand and wheels.
ATTENTION: Take care when turning the unit onto its wheels as the unit has an uneven weight distribution.
4.3.3- Collection box (Fig.4)
To insert the collection box:
Press down the lock button (A).
Then insert the collection box into the sliding rails (8).
Press the lock button (A) upward.
To remove the collection box:
Press down the lock button (A).
Then slide the collection box out of the undercarriage.
Note: Before you remove and empty the collection box,
ensure that the machine has been disconnected from its
power supply.
INSTRUCTIONS ORIGINALES
Fig.3a
Fig.3d
Fig.3b
Fig.3e
Fig.4
Page 22 / 29