Getting Started - Hyundai HBVE2800 Original Instructions Manual

3.3.3- Before maintenance and storage
- Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condition.
- Check the debris collection box frequently for signs of wear and/or deterioration.
- Replace any worn or damaged parts.
- Make sure to use only genuine/original replacement parts and accessories.
- For reasons of safety, any worn or damaged component should be replaced or repaired
immediately by a qualified technician.
- When not in use, store the machine only in a dry place that is inaccessible to children.
3.3.4- Before starting the product
- Only operate the product after completely assembling it.
Do NOT operate product if it is not fully and properly assembled!
- Before each use, check the machine for any signs of damage.
- Prior to each use, check the power cord for signs of damage. Under no circumstances should the
power cord be used if it shows any signs of damage.
- Ensure that the machine is only connected to conventional sockets with a 230-240V
alternating current supply. Only use extension cables if they are really necessary. The use of
extension cables may cause a drop in voltage, which will result in the machine not performing to
its peak or the motor overheating.
- The machine can be plugged into any 230-240 volt AC outlet with 10 amps of fuse protection.
The electrical outlet is to be protected by an earth leakage circuit breaker (ELCB) with a max
triggering current of 30mA (i.e. the appliance should be supplied via a Residual Current Device
(RCD) with a tripping current of not more than 30mA).
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not missing or damaged.
- If you find anything part missing or damaged, do not operate the
tool until the part has been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
4.2- Content
The unit package contains:
- Main unit
- 1 Collection box
- 1 Push stick
- Hex Wrench
- Instructions manual
4.3- Assembly
The machine requires some assembly prior to first time use.
This includes fitting the wheels, the tubes (support feet) to the housing and collection box.
4.3.1- Tubes (Support Feet, see Fig.2)
Turn the shredder upside down and pivot the tubes (support feet) upward.
INSTRUCTIONS ORIGINALES
Page 21 / 29