Hyundai HBVE2800 Original Instructions Manual page 20

irritation.
- Each time before you use the machine, check the integrity of the product's power cord and your
own extension cord for signs of damage and ageing. Do not use the machine if the cord is
damaged or worn. The product should only be operated when its accessories are in perfect
working order.
Any damaged or defective components should be repaired immediately by a qualified technician.
Never attempt to use an incomplete, not fully assembled or modified machine.
- Under no circumstances should the machine be operated while safety devices, protections,
defective guards or shields are damaged or if safety equipment such as collection box is not
installed.
- Only use a weather proof extension cable fitted with coupler to IEC 60320-2-3.
Only extension cords that are rated for outdoor use should be used outdoors.
Any extension cord used should have a minimum cross section of 1.5mm
should have an earth contact and water-spray shielding.
3.3.2- During use
- Always direct the cable to the rear away from the appliance. Make sure the power cord is kept
behind and away from the device while you work.
- If the power cord or extension cord becomes damaged during use, disconnect the supply cord
from the mains immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY
CORD FROM ITS POWER SOURCE.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
- Do not carry the appliance by the cable. Never use the power cord as a handle to lift or carry the
device.
- Always disconnect the product from the mains supply in the following circumstances:
. whenever you leave the machines; when the machine is not in use, is being
carried/transported, or is left unattended.
. before clearing a blockage; while examining, cleaning or unclogging the product.
. before checking, cleaning or working on the product, performing maintenance on it, or
attaching accessories to it.
. If the cutting device strikes a foreign object (e.g. small stone, piece of metal...) or starts to
vibrate abnormally.
- Use the machine in daylight or with adequate illumination (good artificial light).
- Do not overreach. Keep proper footing and balance at all times.
- Bear in mind that the force generated by an electrical device can make you lose your balance.
Therefore, make sure that your feet are firmly planted and that your body is well balanced when
you are operating the product.
- Never operate the machine on damp areas or wet grass.
- Do NOT use the machine on slope areas.
- Keep the chute outlet and ventilation holes (cooling air inlets) unobstructed, clear of debris and
clean at all times.
- Do not assume of your knowledge of the machine. Remember that a split second of negligence is
sufficient to cause serious damage. Be aware of your surroundings and stay alert for potential
hazards that you may not hear while operating the product.
- Keep a safe distance from the ejection zone when working with the tool.
- Be especially careful that material contains no metal parts, stones, bottles, cans or other foreign
objects before inserting into the tool.
- If the cutting mechanism strikes a foreign object or the tool starts to make strange noises or
vibrate, immediately stop tool so as to stop the cutting device.
INSTRUCTIONS ORIGINALES
2
. All plug-in connections
Page 20 / 29