Hyundai HBVE2800 Original Instructions Manual page 19

10. Do NOT expose to and do not use during bad weather conditions: never
work in bad weather (e.g. rain, storm, snow, high wind ...), never work when
visibility is poor or in very high or low temperatures. Never leave product
outdoors under the rain.
11. Keep the handles dry, clean and free of grease, oil or fuel.
12. Operate the product only in outdoors or in well ventilated areas.
13. Do not operate the product on slopes or any other unstable location.
14.1. Become familiar with the controls and the proper use of the equipment.
14.2. Store idle machine. When not in use, product should be stored in a dry, locked up place,
out of reach of children.
14.3. Do not force the tool.
It will do the job better and safer at the rate speed for which it is intended.
The product will do a better and safer job if it is used only for the purposes it was designed
for.
14.4. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are removed from the
machine before operating it.
14.5. Defective switches or other part that is damaged should be properly repaired or
replaced by an authorized service centre. Do not use the machine if the switch does not turn
it on and off.
14.6. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user or operator is solely responsible for accidents or hazards or any damages or injury
caused to properties and/or persons and/or animals.
The user/operator is responsible for the safety of third persons present or entering the work
area.
14.7. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all
the conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
3.3- Safety precautions
3.3.1- Initial preparation before operation
- When you operate the machine, always wear full-length trousers, as well as sturdy, closed
footwear that provide good support. Do NOT operate the machine wearing shorts, when barefoot
or wearing open sandals!
- Do not wear loose clothing or jewellery that can be drawn into the inlet. Keep long hair away
from the inlet.
Under no circumstances should jewellery, any other body ornamentation, or loose clothing be
worn while operating the tool as these items could be drawn into the suction orifice.
When working outdoors, rubber gloves and non-slip footwear should always be worn.
If you have long hair, put it in a hair net.
- Wear protective equipment and always wear protective goggles while operating the tool.
Wearing protective equipment such as a dust mask, non-slip footwear, protective gloves, a helmet
and/or hearing protection (depending on the type and application of the electrical device
concerned) reduces the risk of injury.
- When performing work that generates dust, wear a dust protective mask to prevent dust
INSTRUCTIONS ORIGINALES
Page 19 / 29