Camera; Removing The Camera - Dell P139G Service Manual
Hide thumbs
Also See for P139G:
- Service manual (139 pages) ,
- Setup and specifications manual (30 pages) ,
- Re-imaging manual (18 pages)
Table of Contents
Advertisement
About this task
The following image indicates the location of the LED board and provides a visual representation of the installation procedure.
Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the single screw (M2x3) to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the LED board and the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Camera
Removing the camera
Prerequisites
NOTE:
The camera removal procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1 configuration.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
display
assembly.
5. Remove the
display
bezel.
6. Remove the
display
hinges.
7. Remove the
display
panel.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
77
Advertisement
Table of Contents
