Display Bezel; Removing The Display Bezel - Dell P139G Service Manual

8. Route the antenna cables underneath the fan.
9. Connect the IR camera cable to its connector on the system board and close the latch.
10. Adhere the tape that secures the IR camera cable to its connector on the system board.
11. Connect the display cable to its connector on the system board.
12. Adhere the tape that secures the IR camera cable to the system board.
13. Place the display cable bracket onto the display cable.
14. Replace the single screw (M2x4) to secure the display cable bracket.
Next steps
1. Install the battery.
2. Install the WWAN card
3. Install the WLAN card.
4. Install the base cover.
5. Follow the procedure in

Display bezel

Removing the display bezel

Prerequisites
NOTE: The display bezel removal procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1 configuration.
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the removal procedure.
(optional).
after working inside your
before working inside your
computer.
computer.
Removing and installing components 59