Canon iPF710 Service Manual page 47

Chapter 1
[Maintenance]
Setting Item
[Maint. cart.]
[Replace P.head]
[Repl. S. Cleaner]
[Change Cutter]
[Move Printer]
[System Setup]
Setting Item
[Warning]
[Keep Media Size]
[Paper Size Basis]
1-36
When exchanging the maintenance cartridge, choose Yes and follow the
instructions on the screen.
Not displayed during a warning message that the remaining Maintenance
Cartridge capacity is low.
When replacing the Printhead , choose Yes and follow the instructions on
the screen.
When replacing the shaft cleaner, select [Yes] and take appropriate actions
according to the instructions shown on the screen.
When replacing the cutter unit, select [Yes] and take appropriate actions
according to the instructions shown on the screen. Replacing the cutter unit
will reset the cut count.
Not displayed during a warning message that the remaining Maintenance
Cartridge capacity is low.
When transferring the printer to another location, choose Yes and follow
the instructions on the screen.
[Buzzer] Set the buzzer. Choose On for the buzzer to sound in case of
errors.
[Detect Mismatch] Choose Warning for notification (display of a warning
message) during printing if the paper type specified in the
printer menu does not match the paper type in the printer
driver. Choose None to continue print without notification.
Choose Pause to have printing paused under these
circumstances. In this case, you can continue printing by
pressing the Online button.
Choose On to use the paper size setting as the basis for
printing instead of other settings. The margin setting of the
printer menu will be used instead of the margin setting of the
printer driver if the latter is smaller, which may prevent text
or images in the margin from being printed. Choose Off to
use the printer driver settings instead. Even if the margin
setting of the printer driver is smaller than that of the printer
driver, text or images will not be cut off. However, this
requires longer paper because the actual margin will be equal
to the margin setting of the printer driver plus the margin
setting of the printer menu.
[Sht Selection 1] Select which size is to be recognized, [ISO A3+] or
[13"x19"(Super B)], when the detected size of the cut sheet
is between these sizes.
T-1-16
Description, Instructions
T-1-17
Description, Instructions