Advertisement
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten the Nuts and Bolts until instructed to do so.
B.) Attach Front Support Frame (#1) to Rear Support Frame (#2). Secure them together
with one M10 x 1" Allen Bolt (#34), two Ø ¾" Washers (#45), and one M10 aircraft Nut
(#43) on each end.
C.) Attach a Ø ¾" Rubber Spacer (#24) to the lower hole on Rear Support Frame. Attach
one Short Horizontal Support to the Spacer. Align the holes. Secure the Short
Horizontal Support, Spacer, and Rear Support Frame together with one M8 x 2 5/8"
Allen Bolt (#37), one Ø 5/8" Washer (#46), and one M8 Aircraft Nut (#43). Repeat the
same procedure to install the Right Long Horizontal Support (#4) to Front Support
Frame.
D.) Connect the Short and Long Horizontal Support together with one M6 x ½" Allen Bolt
(#33), one Ø ½" Washer (#47), and one M6 Aircraft Nut (#44).
E.) Repeat Procedure C & D to install the other side.
F.) Press down the Short and Long Horizontal Support completely to stabilize the Front
and Rear Support Frame.
G.) Securely tighten all Nuts and Bolts installed.
5
Advertisement
