Page 1
NOTE: Please read all instructions carefully before using this product COMPETITOR Table of Contents WEIGHT BENCH Safety Notice CB-181 Hardware Identifier Assembly Instruction Parts List Warranty Ordering Parts Model CB-181 Retain This Manual for Reference 08-12-09 OWNER'S MANUAL ® IMPEX INC.
EXPLODED DIAGRAM……………………………………………………………… PARTS LIST....................…… WARRANTY....................…. ORDERING PARTS..................… BEFORE YOU BEGIN Thank you for selecting the COMPETITOR CB-181 Weight Bench by ® IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT. SAVE THESE INSTRUCTIONS.
Page 4
WARNING LABEL PLACEMENT The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
ASSEMBLY INSTRUCTION Tools Required for Assembling this Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Do not tighten Nuts and Bolts until instructed to do so. B.) Connect the Right &...
Page 7
STEP 2 (See Diagram 2) A.) Attach the Main Seat Support (#4) to the Front Post (#5). Secure it with two M10 x 2 ¼” Hex Bolts (#22), one 1 ½” x 4 ½” Bracket (#11), four Ø ¾” Washers (#26), and two M10 Aircraft Nuts (#30).
Page 8
STEP 3 (See Diagram 3) A.) Attach the Leg Developer (#6) to the open bracket on the Front Post (#5). Secure it with one M8 x 2 ¾” Hex Bolt (#23), two Ø 5/8” Washers (#27), and one M8 Aircraft Nut (#29).
Page 9
STEP 4 (See Diagram 4) A.) Attach the bottom side-holes on Backrest Supports (#8) to the pivot on the Main Seat Support (#4). Rest the other end against the Backrest Adjustment Bar (#7). B.) Attach the Backrest Board (#12) to the Backrest Support. Secure it with four M6 x 1 ½”...
PARTS LIST KEY NO. DESCRIPTION QUANTITY Right Upright Beam Left Upright Beam Cross Brace Main Seat Support Front Post Leg Developer Backrest Adjustment Bar Backrest Support Foam Tube 1 ¾” x 2 ¾” Bracket 1 ½’ x 4 ½” Bracket Backrest Board Seat Pad Foam Roll...
IMPEX. IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in connection with the use or performance of the product or other damages with respect to any economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other consequential damages or whatsoever natures.