Table of Contents
Advertisement
3
Installation
To make the product ready for use, review the information in the user manual and take care that the
electricity, tap water supply and water drainage systems are appropriate. If they are not, call a qualified
technician and plumber to have any necessary arrangements carried out.
DANGER
B
¾ Have the installation and electrical connections of the product made by
competent persons. Manufacturer shall not be held liable for damages
that may arise from procedures carried out by unauthorized persons.
DANGER
¾ Product The weight of your product is not suitable to be carried by one
person.
A
CAUTION
¾ Prior to installation, visually check if the product has any defects on it. If
so, do not have it installed. Damaged products cause risks for your safety.
CAUTION
A
¾ Preparation of the location and electrical, tap water and waste water installations at
the place of installation are under customer's responsibility.
¾ Make sure that the water inlet and discharge hoses as well as the power cable
are not folded, pinched or crushed while pushing the product into its place after
installation or cleaning procedures.
3.1 Appropriate installation location
Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces.
Do not place the product on the power cable.
Do not install the product at places where temperature may fall below 0ºC. (See, Warnings for drying)
Place the product at least 1.5 cm away from the edges of other furniture.
There should not be any lockable, sliding or hinged door that may restrain the loading door to open fully
in the installation place of this product.
Operate the product in a well-ventilated and dust-free environment.
14 / EN
Washer-Dryer
Advertisement
Table of Contents
