Assembly - Craftsman 580.752120 Operator's Manual

Your cleaning system requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Cleaning Tank Assembly
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting and Spray
Tip Holder
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• Gun Holder Wireform
• Detergent Siphoning Hose/Filter
• Bag containing 4 multi–colored Spray Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• "L" Bolt
• Plastic Knobs (4)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and cleaning tank.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.

ASSEMBLY

7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Cleaning Tank
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
C
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
A
3. Place cleaning tank (B) over holes (C) on handle
(viewing from front of unit). Push the tree clips (A) into
the holes until they sit flat against the cleaning tank.
4. Insert "L" bolt (A) through hole just above cleaning tank
on right side of handle (viewing from front of unit). Hold
bolt in place and attach plastic knob (B) from inside of
unit. Tighten by hand.
7
A
B
B
B
C
B
A
A