Bpt YC/300 - Intercom System Installation Manual

THESE INSTRUCTIONS SHOULD BE ATTACHED TO THE APPARATUS

HANDSET YC/300

Receiver compatible with the X2 TECHNOLOGY system and system 300.
It can accommodate the loudspeaker YAL to make the call note more powerful.
It features the following controls:

Door lock release (¹)

Auxiliary

(¹) This control can only be used if the unit is on.
By using actuators VLS/300 or customizing control unit XA/300LR by means of programmer MPP/300LR or PCS/300, you can have the control enabled at all times.

Function of each terminal (fig. 5)

Terminal block M1

Function of jumper SW1 (Call attenuated)

Normally supplied ready inserted. Remove the jumper SW1 (fig. 5) in the event the volume of the call note is to be attenuated, or if you have a number of receivers activated by the same call.

Maximum number of receivers activated by same call:

• 3 with normal call (jumper SW1 inserted);
• 2 with normal call and 6 with attenuated call (jumper SW1 not inserted).

Loudspeaker YAL should be considered as a receiver.

Personal door-bell button

The receiver is fitted with a differentiated call input (terminal ) (i.e.: for personal door-bell) a continuous tone call (approximately 2 s).

Technical features

• Power supply: from data line itself.
• Current demand: 0,5 mA.
• Maximum number of receivers that can be connected to control unit XA/300LR: 200.
• Maximum number of receivers that can be connected to an X2 entry panel: 64.
• Audio/data connection line: nonpolarized twisted pair Z = 100 Ω.
• Working temperature range: 0°C to+35°C.

Installation

First, remove the housing (fig. 1) and fasten the base directly to the wall (fig. 2) or to the embedding box (fig. 3 or 4).

If walls are not perfectly level, do not overtighten screws.

In installations with XA/300LR we recommend you gather up the receiver's ID (SN) codes, applied on the outside of the housing, and enter them in the tables that come with the XA/300LR, MPP/300LR and IPC/300LR.
When programming the unit through the MPP/300LR unit, use the dedicated profile for the XC/300 receiver.