Bpt YC/300 US - Intercom System Installation Manual

Also See for YC/300 US:

Advertisement

Bpt YC/300 US - Intercom System Installation Manual

Description of the device

Receiver compatible with the X2 TECHNOLOGY system and system 300.

It can accommodate the loudspeaker YAL to make the call note more powerful.

It features the following controls:

Door lock release (1)
Auxiliary

(1) This control can only be used if the unit is on.
By using actuators VLS/300 or customizing control unit XA/300LR by means of programmer PCS/300, you can have the control enabled at all times.

Function of each terminal

Terminal block M1 (fig. 5)
Function of each terminal

line
personal door-bell
connection for YAL loudspeaker

Function of jumper SW1 (Call attenuated)

Normally supplied ready inserted. Remove the jumper SW1 (fig. 5) in the event the volume of the call note is to be attenuated, or if you have a number of receivers activated by the same call. Maximum number of receivers activated by same call:

  • 3 with normal call (jumper SW1 inserted);
  • 2 with normal call and 6 with attenuated call (jumper SW1 not inserted).


Loudspeaker YAL should be considered as a receiver.

The receiver is fitted with a differentiated call input (terminal ) (i.e.: for personal door-bell) a continuous tone call (approximately 2 s).

Technical features

  • Power supply: from data line itself.
  • Current demand: 0,5 mA.
  • Maximum number of receivers thatcan be connected to control unit XA/300LR: 200.
  • Maximum number of receivers thatcan be connected to an X2 entry panel: 64.
  • Audio/data connection line: non polarized twisted pair Z = 100 Ω.
  • Working temperature range: 0°C to +35°C.

Installation

First, remove the housing (fig. 1) and fasten the base directly to the wall (fig. 2) or to the embedding box (fig. 3 or 4). If walls are not perfectly level, do not overtighten screws.

Installation


In installations with XA/300LR we recommend you gather up the receiver's ID (SN) codes, applied on the outside of the housing, and enter them in the tables that come with the XA/300LR and IPC/300LR.
When programming the unit through the PCS/300 unit, use the dedicated profile for the XC/300 receiver.

BPT S.p. A.
Via Cornia, 1
33079 Sesto al Reghena-PN-Italy
info@bpt.it – www.bpt.it

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Bpt YC/300 US - Intercom System Installation Manual

Advertisement

Need help?

Need help?

Do you have a question about the YC/300 US and is the answer not in the manual?

Questions and answers

Table of Contents