Stihl RMI 422 Instruction Manual page 178

– Contact your STIHL specialist dealer if
the problem persists
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
– Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
– Robotic mower is located outside
mowing area
Remedy:
– Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– RMI 422:
Tilt sensor has detected a slope
inclination exceeding 35%
176
– RMI 422 P:
Tilt sensor has detected a slope
inclination exceeding 40%
Remedy:
– RMI 422:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 35%
– RMI 422 P:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 40%
Message:
1170 – No signal
Switch on docking station
Possible cause:
11.10) – Docking station is switched off
– No reception of wire signal during
operation
– Robotic mower is located outside
mowing area
– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to docking station
– Check LED on docking station – the red
LED must be permanently illuminated
during operation (
– Return robotic mower to mowing area
– Link robotic mower and docking station
( 9.11)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
Remedy:
– Check LED on the docking station,
– Check docking (
– Check funnel-shaped entrance and exit
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
Remedy:
– Dock robotic mower once docking
Message:
1200 – Mowing motor fault
Mowing motor start not possible after 5
attempts
Possible cause:
– Dirt between carrier plate and mowing
– Mowing motor cannot be switched on
– Mowing motor overloaded
13.1)
Remedy:
– Clean mowing blade and mowing deck
– Set higher cutting height (
– Level out any uneven areas (holes,
installed incorrectly
switch on the docking station if
necessary ( 13.1)
15.6)
areas of the corridor ( 12.11)
robotic mower
station is unoccupied again
deck housing
( 16.2)
Clean carrier plate ( 16.6)
depressions) in the mowing area
0478 131 9963 F - EN
9.5)