Stihl RMI 422 Instruction Manual page 133

Fit the grommets over the terminal blocks.
Check the seating of the wire ends in the
terminal block: the two wire ends must be
firmly fastened.
● Close the panel. ( 9.2)
Close the cover of the cable duct (1).
● After completing this installation
work, press the OK button.
0478 131 9963 F - EN
Install the cover. ( 9.2)
Press the OK button.
Connect the power supply unit plug
to the mains, then press the OK
button.
When the perimeter wire is correctly
installed and the docking station is
connected to the mains power supply, the
LED (1) illuminates.
Note the "Docking station controls"
section, particularly if the LED does
not illuminate as described. (
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
display.
9.2)
131