Advertisement
GUIDE BAR
When the guide bar is removed, clear sawdust in the bar groove and the oiling port (1). Grease the nose
sprocket (3) from the grease port (2) on the tip of the bar using a grease gun.
OTHERS
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and guide bar
mounting. If any defects are found, make sure to have them repaired before operating again.
SERVICE POINTS
CYLINDER FINS
Dust clogging between the cylinder fins will cause overheating of the engine. Periodically check and clean the
cylinder fins after removing the air cleaner and the cylinder cover. When installing the cylinder cover, make
sure that switch wires and grommets are positioned correctly in place.
FUEL FILTER
Using a wire hook, take out the filter from the filler port. Disassemble the filter and wash with petrol or replace
with a new one if needed. IMPORTANT - After removing the filter, use a pinch to hold the end of the suction
pipe. When assembling the filter, take care not to allow filter fibres or dust inside the suction pipe.
29
Advertisement
