Advertisement
6
CONTROLS AND SETTINGS
1
NOTE
Your dishwasher uses a DishSense
Technology to understand how much
food is on the dishes and then adjusts
the cycle accordingly.
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that
the water is connected and turned on.
Failure to do so may cause damage
to the pump seal and result in water
leakage.
NOTE
The dishwasher is programmed to
remember your last cycle so you do not
have to reset each time. To start the
dishwasher using the same cycle and
options selected on the previous wash,
just press the START/CANCEL pad.
Recommended Cycle for typical
use:
The Normal Wash cycle with its factory
default options of normal temperature
and heated dry together provide the
best all around performance. This cycle
selection is recommended for everyday
use and is suitable for a large range of
both dish load sizes and food quantities
remaining on those dishes.
NOTE
Not all cycles and options available on
all models.
2
3
TM
4
Option Selections
Wash Cycle Selections:
1
Cycle times are approximate and will
vary with options selected. Hot water
is necessary to activate dishwasher
detergent and melt fatty food soils.
An automatic sensor will check the
incoming water temperature and, if
it is not hot enough, the cycle will
be lengthened for automatic water
heating in the main wash and final
rinse of all cycles. This happens even
when the Heavy wash option has not
been selected. When Heavy wash is
selected, an even higher temperature
will be reached to handle heavier soil
loads.
The DishSense
the soil level on your dishes in the
Heavy Wash, and Normal Wash
cycles. Depending on soil level, the
sensor will determine if additional
water fills are needed to clean
the dishes or if water fills can be
deleted. Cycle time and water usage
will vary based on the amount of
soil on the dishes. Cycle time will
also vary based on the options
selected and the incoming water
temperature.
Temp
2
The programmed cycles default to
the Normal wash cycle option. Press
the Temp pad to choose Sanitize or
High.
Sanitize Option
To sanitize your dishes and
glassware, select Sanitize option.
When selected, the light will come
on and remain on until end of cycle.
The water temperature in the final
rinse will be raised to 155
and will maintain that temperature
for 9 minutes. This option is available
in Heavy and Normal wash cycles.
Only these sanitization cycles
have been designed to meet NSF
requirements.
5
6
Technology checks
TM
F (68
C)
o
o
Advertisement
