Table of Contents
Advertisement
Before use
CaUtion
f Insert the dustbin before using POWERbot.
f Be careful with the followings for proper
automatic recharging.
– Always turn on the power of the docking
station.
– Install the docking station where POWERbot
can easily find.
– Do not leave any object in front of the docking
station.
f When installing the docking station, do not
leave the cord carelessly on the floor since
POWERbot may get tangled by it.
f Do not use POWERbot on black colored
floors.
– The POWERbot may not be able to operate
normally.
f Do not pick up POWERbot by the dustbin
holder.
f Do not place any objects within 2 ft (0.5 m)
to both sides and 4 ft (1 m) to the front of the
docking station.
f Make sure the docking station's charging
contact is not damaged or have any foreign
matters on it.
f Do not install the docking station in an area
with a dark floor.
– If the floor around the docking station is dark,
recharging is hindered.
f Move any obstacles that may disturb
POWERbot's movement (such as children's
indoor swing or slides) before cleaning.
All manuals and user guides at all-guides.com
f Using POWERbot on thick carpet may
f Do not use POWERbot on tables or other
f The POWERbot may bump into chair, desk
f When POWERbot is operating, do not lift it up
f Do not hold by driving wheels of POWERbot
f Do not put any objects on top of POWERbot
f Remove any large papers or plastic bags
f Do not aim the red pointer directly at people
f Prevent any damage to POWERbot by
f Do not disassemble or repair POWERbot.
f Always keep the obstacle sensor and cliff
ENGLISH-09
in use
CaUtion
damage both POWERbot and the carpet.
– The POWERbot cannot pass over carpet that is
thicker than 0.4 in (1 cm).
high surfaces.
– There is a risk of damage if it falls.
legs therefore move them away for faster and
efficient cleaning.
or carry it to another area.
when carrying it to another area.
since it may cause malfunction.
immediately when using POWERbot since
they may block the intake.
or animals.
Cleaning and
CaUtion
maintenance
complying with the following.
– Do not clean POWERbot by spraying water
directly onto it or use benzene, thinner, acetone
or alcohol to clean it.
This should only be done by a certified
repairman.
sensor clean.
– If foreign matter accumulates, sensors may
malfunction.
Advertisement
Table of Contents
