Table of Contents
Advertisement
6. Start the programme - the end of a programme
Starting a programme
Touch the flashing Start/Stop sensor.
The door will lock ( will appear in the
display to show this) and the pro-
gramme will start.
If a delay start time has been selected,
then this will count down in the time
display. At the end of the delay start
time or immediately after the pro-
gramme has started the programme
duration will appear in the time display.
Energy savings
After 10 minutes, the indicators dim.
The Start/Stop sensor flashes slowly.
To reactivate the indicators:
Touch the Start/Stop sensor (this
does not have any effect on a pro-
gramme that is running).
End of programme
The door is still locked during the Anti-
crease phase and the following will ap-
pear alternately in the display:
Finish/Anti-crease
and
Press Stop button
Touch the Start/Stop sensor. The
door will unlock.
Pull open the door.
Remove the laundry.
38
Items left in the drum could discolour
other items in the next wash or be-
come discoloured themselves.
Check that all items have been re-
moved from the drum!
Check the folds in the door seal for
any small articles, e.g. buttons, which
might be lodged there.
Tip: Leave the door slightly open to al-
low the drum to dry.
Turn the programme selector to the
position. This switches the wash-
ing machine off.
If applicable, remove the used cap-
OK
sule from the detergent dispensing
drawer.
Tip: Leave the detergent dispenser
drawer slightly open to allow it to dry.
OK
Advertisement
Table of Contents
