Maintenance; Service Information - Black & Decker HNV215BW52 Instruction Manual

• While holding the dust bowl over a bin or
sink, pull out the filters (6) to empty the
contents as shown in Figure E.
• To replace the dust bowl, push it back onto
the handle until it clicks firmly into place.
WARNING:
without the filters. Optimum dust collection
will only be achieved with clean filters.
E
Cleaning the dust bowl and filter
• The dust bowl and filters can be washed in
warm soapy water.
• Make sure the filters and the dust bowl are
dry before refitting.
Replacing the filters
The filters should be replaced every 6 to 9
months and whenever worn or damaged.
Replacement filters are available from your
BLACK+DECKER dealer.

MAINTENANCE

Use only mild soap and damp cloth to clean
the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
WARNING:
is completely dry before using it.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
The RBRC™ Seal
The RBRC® (Rechargeable
Battery Recycling Corp oration)
Seal on the lithium-ion batteries
(or battery packs) indicates
that the costs to recycle these batteries
(or battery packs) at the end of their
useful life have already been paid by
BLACK+DECKER. In some areas, it is
illegal to place spent lithium-ion batteries in
the trash or municipal solid waste stream
and the Call 2 Recycle® program provides
an environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with
BLACK+DECKER and other battery users,
This manual downloaded from http://www.manualowl.com
Never use the appliance
Make sure the vacuum
has established the program in the United
States and Canada to facilitate the collection
of spent lithium-ion batteries. Help protect
our environment and conserve natural
resources by returning the spent nickel
cadmium, nickel metal hydride or lithium-ion
batteries to an authorized BLACK+DECKER
service center or to your local retailer for
recycling. You may also contact your local
recycling center for information on where
to drop off the spent battery. RBRC® is a
registered trademark of Call 2 Recycle, Inc.
Accessories
Recommended accessories for use with
your appliance are available from your local
dealer or authorized service center. If you
need assistance regarding accessories,
please call: 1-800-544-6986.
WARNING:
accessory not recommended for use with
this appliance could be hazardous.

SERVICE INFORMATION

All BLACK+DECKER Service Centers
are staffed with trained personnel to
provide customers with efficient and
reliable power tool service. Whether you
need technical advice, repair, or genuine
factory replacement parts, contact the
BLACK+DECKER location nearest you. To
find your local service location, call: 1-800-
544-6986 or visit
www.blackanddecker.com
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
5
The use of any