Craftsman 247.881722 Operator's Manual page 9

5. Pivot flange keepers out and position the chute assembly over the base.
See Figure 4.
6. Close the flange keepers to secure the chute assembly to the chute base.
See Figure 5. The flange keepers will click into place when properly secure.
NOTE: If the flange keepers will not easily click into place, use the palm of
your hand to apply swift, firm pressure to the back of each.
7. Remove the cap, flat washer, and hairpin clip from the end of the chute
directional control.
8. Insert the end of the chute directional control into the lower bracket and
secure with the flat washer and hairpin clip removed in Step 7. See Figure
6. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket
Adjustment on page 19 in the Service & Maintenance section.
Figure 4
ASSEMBLY
9
Figure 5
Figure 6