Table of Contents
Advertisement
splashes from baking and roasting while the appliance
is in operation.
If the self-cleaning surfaces no longer clean themselves
sufficiently and dark stains appear, they can be cleaned
using the cleaning function. To do this, refer to the
information in the relevant section. ~ "Cleaning
function" on page 19
Caution!
Do not use oven cleaner on self-cleaning surfaces. This
will damage the surfaces. If oven cleaner does get onto
these surfaces, dab it off immediately using water and a
sponge cloth. Do not rub the surface and do not use
abrasive cleaning aids.
Keeping the appliance clean
Always keep the appliance clean and remove dirt
immediately so that stubborn deposits of dirt do not
build up.
Tips
Clean the cooking compartment after each use. This
■
will ensure that dirt cannot be baked on.
Always remove flecks of limescale, grease, starch
■
and albumin (e.g. egg white) immediately.
Use the universal pan for baking very moist cakes.
■
Use suitable ovenware for roasting, e.g. a roasting
■
dish.
pRails
With good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Pull out the pull-out forwards.
1.
Push the front rail forwards and up (fig.
2.
detach it (fig.
).
"
Then swing the entire rail outwards
3.
at the rear
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Inserting the holders
If the holders fall out when you remove the rails, these
must be re-inserted.
The holders at the front differ from those at the rear
1.
(fig.
Use the hook to mount the front holder at the top
2.
into the round hole
it at the bottom, and straighten it
Use the hook to attach the rear holder into the upper
3.
hole
) and
!
Attaching the rails
When hanging the rails, ensure that the pull-out is at the
bottom.
(fig.
).
ƒ
#
).
!
‚
, set it at a slight incline, attach
‚
and push it into the lower hole
Rails
en
and detach it
‚
(fig.
).
ƒ
"
ƒ
(fig.
).
#
21
Advertisement
Table of Contents
