modway EEI-2232 Manual

EEI –2232/2233

Thank you for purchasing the MODWAY CHAIR!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Chair Back

Customer Service 908-368-1025︱www.modwayfurniture.com

CHAIR

Seat Frame x1

Bolt M8x57mm

x 9

Spring Washer M8

x 9

Flat Washer M8

x 9

Allen Wrench

x 1

Front Leg

Page 1 of 3

Table of Contents

Need help?

Do you have a question about the EEI-2232 and is the answer not in the manual?

Page 1 EEI –2232/2233 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI –2232/2233 CHAIR STEP 1: Please put Chair Back (1) upside down on a carpeted or padded area. Then open the zipper on bottom of the Seat Frame (2), The inside of the Seat Frame(2) will now be visible. Attach Seat Frame (2) to Chair Back(1) by using 5 pieces of Bolt (A), 5 pieces of Spring Washer (B) and 5 pieces of Flat Washer (C) as shown.
Page 3 EEI –2232/2233 CHAIR STEP 3: Carefully turn over the chair. Please put a heavy object or seat one adult on top of the Seat Frame (2) to pressure the chair for leveling. Fully tighten all Bolts (A) with Allen Wrench (D). Assembly is completed.

Eei-2233