Page 1
All manuals and user guides at all-guides.com TB7100 base station Installation Guide MBB-00003-03 Issue 3 March 2006...
Page 2
Directive requires that this product be disposed of Limited. separately from the general waste stream when its The word TAIT and the TAIT logo are trademarks of service life is over. Please be environmentally Tait Electronics Limited. responsible and dispose through the original supplier, All trade names referenced are the service mark, your local municipal waste “separate collection”...
The characters xx represent the issue number of the documentation. All available documentation is provided on the Product CD supplied with the base station. Updates may also be published on the Tait support website. Consult your nearest Tait Dealer or Customer Service Organisation for more information...
Page 8
1.3.3 Unauthorised Modifications Any modifications you make to this equipment which are not authorised by Tait Electronics Ltd. may invalidate your compliance authority’s approval to operate the equipment. 1.3.4 Health, Safety and Electromagnetic Compatibility in Europe...
Pozidriv PZ1 screwdriver for the M3 pan head self-tapping screws used to secure the fans. You can also obtain the TBA0ST2 tool kit from your nearest Tait dealer or Customer Service Organisation. It contains the basic tools needed to install, tune and service the base station.
Page 13
DC backup power option. In case of AC mains failure the base station will automatically and seamlessly switch to DC power input. If no internal AC power supply unit is fitted, an external Tait T809-10-87xx power supply can be used to supply the DC voltage required.
Page 14
(front panel mounted down) or side to side. For transport or in installations subject to vibration, the base station should be supported at the rear using a transit bracket (Tait recommends to use the TB7100 transit bracket, Tait part number TBBA03-04). Figure 1.3...
Page 15
Cables must be routed so that they do not restrict the air outlets at the rear of the base station. 1.8.5 Accessories The base station can use the following accessories: 219-03012-00 cable assembly to connect TB7100 to CMM card T809-10-87xx power supply TBBA03-01 wall mounting kit TBBA03-02 duplexer kit (mechanical configuration without provision for internal...
Page 28
Directive 1999/5/EC Declaration of Conformity Dansk Français Undertegnede Tait Electronics Limited erklærer Par la présente, Tait Electronics Limited déclare herved, at følgende udstyr TBBA4A, TBBB1A, que l'appareil TBBA4A, TBBB1A, TBBB1B, TBBB1B, TBBC0A, TBBH5A & TBBH5B TBBC0A, TBBH5A & TBBH5B est conforme overholder de væsentlige krav og øvrige...