RACCEWAY e-BABETA User Manual page 9

HOLDER AND SUITCASE ASSEMBL V
Suitcase with holder is not part of E-BABETA. They can be purchased as an additional assortment
on the website www.motoe.eu
1. Lift the seat and loosen the three self-tapping screws on the top of the plastic, above
the silver one Handle.
2. Remove the four screws from the silver handle and the two screws from the bottom of the
seat above the turn signals and remove the original handle.
4. The housing contains a set of screws for mounting. ln the set you will find:
A } 4x 6 cm long screw with nut and large shaped washer ( copper )
B } 4x 4 cm long screw ( silver )
C } Fiat head screw 2x 2 cm ( gray )
D } 2x profiled sheet metal
5. Attach screws "C" to the seat lock.
6. Attach the trunk holder and tighten the screws "B" from below and from above
7. Tighten the 3 self-tapping screws in the upper plastic and screw in the two screws from
the lower part seats above the turn signal.
8. Remove the two rubber tabs on the lock side from the bottom of the seat.
9. Place the suitcase on the suitcase holder and screw it to the holder - from the inside, place the
screw "A" using Use nuts on the washer and bottom. lt is not necessary to use a washer for the
B
8.
6
C