Table of Contents
Advertisement
8.
Rear Panel Connections
3
3
Step 1
Connect the Ethernet cables.
Step 2
Connect any other required cables.
Step 3
Connect the power cords.
Proceed to
Section 10, Front Panel Operation
Power Supply Status LED
There is a single bi-color Power Good LED on each power
supply module to indicate power supply status. The LED
operation is defined in the table below.
Power Supply Condition
Output ON and OK
No AC power to both power supplies
AC present / only 12 VSB on (PS off) or PS in cold
redundant state
AC cord unplugged or AC power lost; with a
second power supply in parallel still with AC
input power
Power supply warning events where the power
supply continues to operate; high temp, high
power, high current, slow fan
Power supply critical event causing a shutdown;
failure, OCP, OVP, fan fail
Power supply FW updating
In normal operation the Power Good LED on Power Supply Module 1
will be SOLID GREEN and the LED on Power Supply Module 2 will BLINK
GREEN (redundant standby), if the system is powered down both LEDs
will BLINK GREEN.
INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide
(continued)
1
1
CAUTION
The power supply is hot-swappable only when you have
a server with redundant power supplies installed. If you
on page 11.
only have one power supply installed, before removing
or replacing the power supply, you must first take the
server out of service, turn off all peripheral devices
connected to the server, turn off the server by pressing
the power button, and unplug the AC power cord from
the server or wall outlet.
NOTE:
The server offers redundant, hot-swap capability.
The connections to AC mains should be made in a
manner appropriate to local code and consistent with
customer power distribution with or without redundant
sources.
LED State
GREEN
OFF
1Hz Blinking
GREEN
AMBER
1Hz Blinking
AMBER
AMBER
2Hz Blinking
GREEN
1
1
1
1
www.insightdlp.com
Page 9
Advertisement
Table of Contents
