INSIGHT DLP SENSOR 910 Hardware Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

INSIGHT DLP SENSOR 910 Appliance

Hardware Installation Guide

Table of Contents

Summary of Contents for INSIGHT DLP SENSOR 910

Page 1 INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide...
Page 2: Table Of Contents
Bezel Installation on the Appliance ..........INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com...
Page 3: Safety Notice And Warnings
100 - 240V 200 - 240 VAC Input frequency range: 47 - 63 Hz (Auto-range) Rated input current: 100 - 127V ~/9.2A Max (x2) 200 - 240V ~/4.4A Max (x2) INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 3...
Page 4: Site Preparation
Install near appropriate AC outlets, and Ethernet hubs or individual jacks. Be sure to install an AC Power Disconnect for the entire rack assembly. The Power Disconnect must be clearly marked. Ground the rack assembly properly to avoid electrical shock. INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 4...
Page 5: Unpacking The Appliance
Complete chassis and adjustable rack rail assembly (outside view) Inner fixed chassis rail Chassis rail locking pin Chassis rail release button Adjustable rack rail, front bracket Adjustable rack rail, center sliding rail Adjustable rack rail, rear bracket INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 5...
Page 6: Prepare And Assemble The Rack Rails
INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 6...
Page 7: Installing The Rails On The Appliance
Carefully slide it out supporting the unit on both sides at all times. INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 7...
Page 8: Rear Panel Connections
Full Height PCIe Expansion Slot VGA Port Three USB Ports Serial Port eth4 Port Not Used (Optional IPMI Port) eth7 Port MGMT Port eth6 Port SPAN Port eth5 Port DLP Port eth3 Port INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 8...
Page 9 In normal operation the Power Good LED on Power Supply Module 1 will be SOLID GREEN and the LED on Power Supply Module 2 will BLINK GREEN (redundant standby), if the system is powered down both LEDs will BLINK GREEN. INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 9...
Page 10: Front Panel Operation
Hard Drive Activity LED failure warning, although still functioning Power Button with Integrated LED Critical, non-recoverable - AMBER Solid - On DLP Activity LED system is halted INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 10...
Page 11: 10. Bezel Installation On The Appliance
Right Fixed ht F ixed Left Flexible Left F lexib Bezel Tab Bezel T Bezel Tab Bezel T INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide www.insightdlp.com Page 11...