Installing The Rails On The Appliance; Installing The Appliance In The Rack - INSIGHT DLP SENSOR 910 Hardware Installation Manual

6. Rail Installation on the Appliance
Locate the fixed chassis rails that were put aside in Step 1 on page 8
n Mount the inner fixed chassis rails to each side of the appliance. Slide the chassis rail key hole cut outs
through the chassis standoff tabs
toward the back of the appliance. The chassis rail locking pin will secure the rail in place.
Chassis standoff tab Chassis stand
Appliance chassis Appliance chassis
(side view) (sid e view)
Inner fixed chassis rail I nner fi xed chassis rai
7.

Installing the Appliance in the Rack

A. Align the inner fixed chassis rails on the appliance with the assembled rack rail components previously
installed in the rack. Carefully slide the appliance into these rails until you hear the rails click into place.
B. Slide the chassis rail release button forward to release the chassis rail. Push the appliance all the way
into the rack.
C. Secure the unit in the rack by pressing the thumb screws on either side of the appliance into the holes in
rack and tighten each one.
C C
NOTE: When removing the appliance from
the rack, you will need to pull the chassis
release button forward in order to release
the appliance from the rack. Carefully slide
it out supporting the unit on both sides at
all times.
INSIGHT DLP SENSOR 910 Appliance Hardware Installation Guide
on the side of the appliance as shown below. Slide the chassis rail
B
off tab off tab Chassis stand Chassis standoff tab
B B
l
Chassis rail locking Chassis rail locking pin
A A
Chassis rail key hole Chassis rail key hole Chassis rail key hole
B B B
C C
off tab off tab Chassis stand Chassis standoff tab
B B
p in in
A A
Chassis rail key hole Chassis rail key hole Chassis rail key hole
A A
B B
off tab off tab
B B
A A
Chassis rail key hole Chassis rail key hole Chassis rail key hole
A A
www.insightdlp.com
A
Page 7