Troubleshooting; Specifications - THOMSON WS502 User Instructions

Comment: The maximum range is approximately 10 metres. Place your Bluetooth speaker as
close as possible to the device to avoid any interference with the connection.
USB operation
1. Insert a USB stick into the USB A port at the rear.
2. Press the Mode/Volume button to select USB mode. The light will turn purple.
*The maximum size of USB media for MP3 playback should not exceed 32 GB.

Troubleshooting

Problem
No sound
Unable to connect
via Bluetooth
The WS502
bookshelf speaker
does not turn on.
Device technical specifications
Type
Tweeter
Peak power
RMS power
S/B ratio
Power consumption
Input power
Impedance of the
speaker
Outputs
Bluetooth pairing
name
Check that the power indicator is ON.
Try increasing the volume using the main volume control.
Make sure the audio cables are securely connected and the input is
properly set to the speakers.
Check if there is an output signal from the audio source.
Make sure that the speaker is set to Bluetooth input; Bluetooth
cannot be paired or connected in another audio input mode.
Disconnect any Bluetooth device by pressing and holding the
volume button in Bluetooth mode, then try again.
The effective Bluetooth transmission range is 10 metres; remember
not to exceed this range.
Try connecting another Bluetooth device.
Check that the unit is properly connected to the mains and the
mains socket is switched on.

Specifications

1.25 inches (5 W)
x 2
50 W
40 W
≥80 dB
0.09W
CC 19 V, 1.65 A
4Ω/woofer, 4Ω/
tweeter
AUX out, Sub out
WS502
- EN 15 -
Solution
Type
Mid-woofer speaker
Wireless frequency
Bluetooth version
EIRP
Distortion
Speaker frequency
Inputs
Transmission range
Dimensions
Specifications
4 inches (30 W) x 1
2,402-2,480 MHz
5.0
-4.9dBm
＜1%
40 Hz - 20 kHz
Bluetooth, Line In
(RCA), USB
10 m
291 x 170 x 153 mm