Troubleshooting Guide - THOMSON MW-1266 Owner's Manual

TROUBLESHOOTING GUIDE

Should you experience difficulties in the use of this player, please refer to
the following chart.
Fault Cause
Unit cannot be Unit crashes and
operated. "hangs"
Speaker is not
paired to the audio
No audio signal
source.
via the
Bluetooth
connection
Volume too low
Pairing does not
work
Audio source is
Speaker cannot
switched off
be connected
Bluetooth
switched off at the
audio source.
Bluetooth version
is not supported.
Poor sound Bluetooth device
quality from a is almost out of
®
Bluetooth range of the
device MW-1266
Low battery.
Remote control
is not
Remote Control
functioning
is not pointed
properly.
to ward the IR
window
Solution
Disconnect from the mains for
around 5 seconds. Then switch the
unit on again.
Check whether a connection exists.
If necessary, pair the speaker
again to the audio source.
Increase the volume on the
speaker
Increase the volume on the the
audio source.
Check whether the audio source
supports the A2DP protocol
Switch on the audio source
is
Switch on the Bluetooth function in
the audio source.
Use a different playback unit.
Move your Bluetooth device
closer to the MW-1266
Replace the battery with correct
type CR2032
Point the Remote Control to ward
the unit IR window, use with in 10
feet of the unit.
10