Celestron TRAVEL SCOPE 70 Quick Setup Manual page 4

ALIGNING THE
FINDERSCOPE
The finder is one of the most important parts of your telescope. It
helps you locate objects and center them in the eyepiece. The first
time you assemble your telescope, you need to align the finder to
the telescope's main optics. It's best to do this during the day*.
* SOLAR WARNING!
Never attempt to view the Sun through any
telescope without a proper solar fi lter
1
CHOOSE A TARGET
Take the telescope outside during the day and find
an easily recognizable object, like a streetlight,
license plate or sign. The object should be as far
away as possible, but at least a quarter mile away.
4
ADJUST THE FINDERSCOPE
Without moving the telescope, use the three finger
knobs on the finderscope bracket to move the finder
around in the bracket until the crosshair appears
over the same object you are observing in the
telescope's 20mm eyepiece.
TIP:
Try adjusting one screw at a time. Loosen one screw by half
a turn and tighten another by the same amount to ensure the
fi nderscope is securely held in place.
3
!
2
Focus Knobs
CENTER THE TARGET
IN THE EYEPIECE
Look through the telescope using your lower
powered eyepiece. Move the telescope until the
object you chose lies in the center of the view. If the
image is blurry, gently turn the focus knobs until it
comes into sharp focus.
5
YOUR FINDERSCOPE IS
NOW ALIGNED!
It should not require realignment unless it is bumped
or dropped.
Low Power Eyepiece 3
LOOK THROUGH FINDERSCOPE
Once the object is centered in your 20mm eyepiece,
look through the finderscope and locate the
crosshair reticle.