Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Temtop P10
Summary of Contents for Temtop P10
- Page 1 Air Quality Monitor...
- Page 2 0 to 500, with higher values indica�ng higher levels of air pollu�on and adverse health effects. AQI assessments can show PM2.5, PM10, O , SO , NO , CO, etc. Temtop calculates AQI according to EPA standards and focuses only on PM2.5 and PM10.
- Page 3 ★ Do not expose the detector to heavily contaminated environments for long periods, as this can damage the sensor. ★ Do not use the detector in wet condi�ons for extended periods to ensure accurate measurements. ★ Do not use the detector for long periods in environments with a strong, irrita�ng smell to ensure accurate measurements.
- Page 5 Follow US EPA particulate pollution standards to calculate AQI. (0.44 lb)
- Page 6 ● For indoor use: Keep the room/area air�ght for 10 minutes to obtain more accurate results. ● On the switch-off screen, the indicator light flashes yellow during charging and is always green when charging is complete. ● If the ba�ery level shows , please charge the detector in �me to avoid being affected during use (it can also recharge when switched off).
- Page 7 PM2.5 concentra�on will auto-display a�er the countdowns: Then press Home Bu�on to display AQI concentra�ons:...
- Page 8 Then press the Home bu�on to display the TVOC concentra�on. Then press the Home bu�on again to display the HCHO index: Manual Loop: Repeat the above steps can manually loop the display in order of PM2.5, AQI, TVOC, and HCHO. Auto Loop: Double press the Home Bu�on can loop each display every 3s.
- Page 9 PM2.5 concentra�on will auto-display a�er turning on countdowns; Then press Home Bu�on to display the AQI index: Manual Loop: Repeat the above steps can manually loop the display in order of PM2.5, AQI. Auto Loop: Double press the Home Bu�on can loop each display every 3s. Double press again to exit Auto Loop mode.
- Page 10 The indicator lights on the panel indicate the corresponding air quality: The ba�ery level indicator on the screen indicates the device charging status: When the ba�ery level is low, please charge it by connec�ng it to the USB cable and power supply.
- Page 11 It is advisable to calibrate the detector a�er three months of use. Calibra�on instruc�ons are as follows: a) Switch on the detector and wait for approximately 10 minutes. b) Press and hold the calibra�on bu�on for more than 1 second using the needle tool un�l the HCHO icon on the screen flashes.
- Page 12 Follow EPA particle pollution standards to calculate the AQI for PM2.5.
- Page 14 Q: Why is the PM2.5 reading constantly changing? A: PM2.5 concentra�ons in the environment are constantly changing, not only due to environmental factors such as changes in airflow, moisture, and wind pa�erns but also due to the presence of such familiar sources as smoking, cooking, vehicle emissions, smoke from coal burning/chimney/stoves, etc.
- Page 15 Q: Which HCHO readings are inaccurate or overestimated at certain times? A: Since Temtop uses a high-precision electrochemical HCHO sensor, its electrochemical response characteris�cs can also respond to gases other than formaldehyde. The table lists the most common gases that interfere with the rela�ve sensi�vity of HCHO sensors.
- Page 16 V3.2...
Need help?
Do you have a question about the P10 and is the answer not in the manual?
Questions and answers