Safety Xpress BOLSM114SS Product Information & Installation Manual

304
Grade
Tools Required:
• Hammer drill with 14mm drill bit for M10
coach screw 100mm, or 10mm drill bit
for M10 concrete screw anchors
• Fixing kit (M10 coach screws 100mm, or
60mm M10 concrete screw anchors, or
100mm M10 concrete screw anchors)
• The correct sized socket
• A hammer
• A hand broom or industrial vacuum
Installation:
1. Read all instruction steps from beginning to
end.
2. Determine exactly where the bollard will be
placed. If you are installing more than one
bollard, it is a good idea to mark the ground to
ensure that you have a straight line to assist you
with the correct placement of your bollards.
3. Using your hammer drill, drill a guide hole in the
surface, through each hole in the bollard using
the drill bit. (This is to mark the surface so that
you know where to continue to drill).
1300 049 246
Surface Mount Bollard
SKU
Material
Colour
Dimensions:
FREE
Item Weight
Fixings
2 2
Fixings
MONTHS MONTHS
PRODUCT INFORMATION &
INSTALLATION GUIDE
Specifications
BOLSM114SS
304 Grade
Stainless Steel
Silver brushed body
Height: 1000mm
Diameter:
114mm (Pole) 200mm (Base)
Wall Thickness: 3mm
Base: 4 Mounting Holes
16mm each in Diameter
10kg
4 x FREE Mounting Bolts Included
per bollard (standard fixings kit)
4.Remove the bollard and brush or vacuum away the
dust.
5. Continue to drill each guide hole to almost the
entire length of your fixings.
6. If you are using a plastic plug component, put it in
the drilled hole and hammer in.
7. Place the bollard over the holes, line up and place
your fixing in the holes and screw or hammer in.
8. Use your socket to tighten the screw if applicable.
Be careful not to over tighten.
www.safetyxpress.com.au