Safety Xpress BOLSM165 Product Information & Installation Manual

Re ective
Tools Required:
• Hammer drill with 14mm drill bit
• Fixing kit
• The correct sized socket
• A hammer
• A hand broom or industrial vacuum
Installation:
1. Read instruction steps from beginning to end.
2. Determine exactly where the bollard will
be placed. If you are installing more than one
bollard, it is a good idea to mark the ground to
ensure that you have a straight line to assist you
with the correct placement of your bollards.
3. Using your hammer drill, drill a guide hole in
the surface, through each hole in the bollard
using the drill bit. (This is to mark the surface so
that you know where to continue to drill).
1300 049 246
PRODUCT INFORMATION &
Surface Mount Bollard
SKU
Material
Colour
Dimensions:
FREE
Fixings
Item Weight
2 2
MONTHS MONTHS
Fixings
4.Remove the bollard and brush or vacuum away
the dust.
5. Continue to drill each guide hole to almost the
entire length of your fixings.
6. If you are using a plastic plug component, put it in
the drilled hole and hammer in.
7. Place the bollard over the holes, line up and place
your fixing in the holes and screw or hammer in.
8. Use your socket to tighten the screw if applicable.
Be careful not to overtighten.
www.safetyxpress.com.au
INSTALLATION GUIDE
Specifications
BOLSM165
Hot Dip Galvanised Steel
Powder Coated
Class 1 Red Reflective Tape
Black Plastic Cap on top
Height: 1300mm
Diameter:
165mm (Pole) 300mm (Base)
Wall Thickness: 3mm
Base: 4 Mounting Holes
16mm each in Diameter
21kg
4 x FREE
Included per bollard
(standard fixings kit)
Yellow with
Mounting Bolts