Assembly - Bissell Cleanview 1822 Series User Manual

Assembly

The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
1
Place handle on
vacuum base and
press down firmly.
4
Place extension wand clip on back
of unit, twist clockwise to lock in.
6
Wrap hose up and around the
hose wrap on the handle. Slide
end of hose into vacuum base.
NOTE: The powerfoot will not suction properly unless the hose is firmly attached.
2
Insert screws in
back of unit.
Tighten by rotating
the screw clockwise
until tightened.
3
click
5
Line up tabs on hose end to vacuum base and
twist clockwise to lock in.
7
Store
TurboBrush®
on handle.
Push upper cord
wrap in firmly until
you hear a "click".
8
Store dusting
brush above
hose wrap in
holder.
www.BISSELL.com
5