Table of Contents
Advertisement
NLTroubleshooting
Malfunction
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum shakes
program start.
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the centrifuge
run.
Drum turns, there
no water flows into
the device.
strong foam
ming.
High centrifuge
rental is not
reached.
50
Cause and Troubleshooting
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
Foam control system performs an extra rinse in case
of excessive foam formation.
No error - no action required.
▶
The water is below the visible range.
No error - no action required.
▶
▶
Do not fill the appliance with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
Insert in compartment is clogged.
→ "Cleaning the detergent drawer", page
▶
40
The appliance is not leveled correctly.
→ "Adjusting the device", page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", page 16
Transport protection devices have not been removed.
→ "Remove transport protection", page 14 .
▶
Load recognition is active.
No error, no action required.
▶
Remark:The load recognition can take up to 2 minutes.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with the same load.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Imbalance control system compensates for
imbalance by reduced spin speed.
Advertisement
Table of Contents
