After Operation; After Operation Safety; Cleaning Under The Machine - Toro Super Recycler 21386 Operator's Manual

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.

Cleaning under the Machine

Service Interval: Before each use or daily
WARNING
The machine may dislodge material from
under the machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you
have completed mowing.
1. Lower the machine to the lowest cutting-height
setting. Refer to
(page 10).
2. Move the machine onto a level surface.
3. Wash out the area under the rear deflector (if
applicable) where the clippings go from the
underside of the machine to the grass bag.
4. Attach a garden hose that is connected to a
water supply to the washout port
1. Washout port
5. Turn the water on.
6. Start the engine and run it until there are no more
clippings that come out from under the machine.
7. Shut off the engine.
8. Shut off the water and disconnect the garden
hose from the machine.
9. Start the engine and run it for a few minutes to
dry the underside of the machine.
10. Shut off the engine and allow it to cool.
18
Adjusting the Cutting Height
(Figure
Figure 21
21).
g195254