Removing The Machine From Storage - Toro Super Recycler 21386 Operator's Manual

Note:
If the level of fuel in the fuel tank is too high, drain the fuel from the fuel tank into an approved fuel
container until it is at or below the level recommended by the engine manufacturer (A of
2. If the grass bag is on the machine, remove it (B of
3. Disengage the handle locks (C of
4. Fold the handle fully forward (D of
Important:
Route the cables to the outside of the handle knobs as you fold the handle.
5. Engage the handle locks (E of
6. Lift the front of the machine by the handle and move it into a storage space (F of
Removing the Machine
from Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine
rapidly by pulling the recoil-start handle to blow
the excess oil from the cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 20 N∙m (15 ft-lb).
4. Perform any maintenance procedures; refer to
Maintenance (page
5. Check the engine-oil level; refer to
Engine-Oil Level (page
Figure 32).
Figure
Figure 32).
20).
Checking the
9).
Figure 31
Figure 32).
32).
Figure 32
6. Fill the fuel tank with fresh fuel; refer to
the Fuel Tank (page
7. Connect the wire to the spark plug.
26
Figure 32).
decal133-8198
Figure 32).
Filling
8).
g311933