Table of Contents
Advertisement
VEHICLE CONTROLS
Interior and Exterior Lights
Operate interior and exterior lights when the vehicle is on or off.
Brightness Control
Adjust instrument panel brightness when the vehicle is on.
To brighten: Turn the knob to the right.
To dim: Turn the knob to the left.
A beep sounds when the brightness reaches
minimum or maximum.
Interior Lights
Change the interior light settings using the front and rear switches on the ceiling.
ON position (rear): Interior lights remain on.
Door-activated position (front): Interior lights come
on when any of the doors are opened, the driver's
door is unlocked, or the vehicle is turned off.
OFF position: Interior lights remain off.
Map lights: Press the map lights to turn on or off.
Exterior Lights
Rotate the switches on the headlight lever to operate the exterior lights.
OFF: All exterior lights are off.
: Turn on exterior lights except headlights.
AUTO: Turn on the automatic lighting feature.
Headlights turn on or off depending on ambient
brightness when the vehicle is on. Headlights
automatically come on after the wipers are
engaged for a certain time.
: Turn on all exterior lights including headlights.
: Turn fog lights* on or off.
38 |
TRIP knob
Front
Off
Door-activated position
Map lights
High beams
Fog
lights*
Flash the high beams
Low beams
*if equipped
Auto High-Beam System*
Automatically changes the low beam headlights to high beam headlights when
necessary.
How It Works
When you are driving at night above 25 mph (40 km/h) and the headlight lever is in the
low beam position with the switch rotated to AUTO, the system changes between low
and high beams depending on the surrounding conditions.
Your vehicle
If a vehicle is detected ahead of you, the headlights stay in low beams. If the system
does not detect any vehicles ahead of you, the headlights change to high beams.
Certain conditions, such as weather and brightness of other vehicles' lights, can affect
system operation.
Turning the System On or Off
Make sure the headlight lever is in the low beam position
with the switch rotated to the AUTO position. The auto
high-beam system indicator appears when the system
is on.
The system cancels temporarily when you drive at
speeds below 15 mph (24 km/h), the vehicle speed is
below 6 mph (10 km/h), or the windshield wipers run at
high speed for more than a few seconds.
To disable the system: When the vehicle is on and parked, pull the headlight lever
towards you and hold it for 40 seconds. The auto high-beam indicator blinks twice.
To re-enable the system: Pull the headlight lever towards you and hold it for 30
seconds. The auto high-beam indicator blinks once.
To temporarily cancel operation, do either of the following:
• Flash the high beams by moving the lever toward you. Flash the high beams again to
resume auto high beam operation.
• Engage high beams by moving the lever into the high beam position. Return the stalk
to the low beam position to resume auto high beam operation.
VEHICLE CONTROLS
Oncoming
vehicle
Vehicle ahead
of you
Headlight Switch
*if equipped
| 39
Advertisement
Table of Contents
