Interior And Exterior Lights; Wiper Operation - Honda CR-Z 2016 Owner's Manual

VEHICLE CONTROLS

Interior and Exterior Lights

Operate interior and exterior lights when the vehicle is on or off.
Brightness Control
Adjust instrument panel brightness when the vehicle is on.
To brighten: Turn the knob to the right.
To dim: Turn the knob to the left.
A beep sounds when the brightness reaches
minimum or maximum.
Interior Lights
Change the interior light settings using the switches on the ceiling. Each front
interior map light can be turned on or off by pressing the lenses.
ON position: Interior lights remain on.
Door-activated position: Interior lights come on
when either door is opened, the driver's door is
unlocked, or the vehicle is turned off.
OFF position: Interior lights remain off.
Exterior Lights
Rotate the switches on the headlight lever to operate the exterior lights. Push the
lever forward to turn on the high beams. Return the lever to its original position for
low beams.
OFF: All exterior lights are off.
: Turn on exterior lights except headlights.
AUTO: Turn on the automatic lighting feature*.
Headlights turn on or off depending on ambient
brightness when the vehicle is on.
: Turn on all exterior lights including headlights.
: Turn fog lights* on or off.
30 |
Control knob
Door-activated
position
Off
On
Map lights
High beams
Fog
lights*
Flash high beams
Low beams
*if equipped

Wiper Operation

The windshield wipers and washers can be used when the vehicle is on.
Front Wipers
Move the wiper lever up or down to the desired
position.
Rotate the intermittent time adjustment ring to
adjust the wiper speed.
Rear Wiper
Rotate the end of the wiper lever to the desired
position.
When you shift to Reverse (R) and the front
wipers are activated, the rear wiper activates
even if the switch is off.
NOTICE
Do not use the wipers when the windshield is dry. The windshield will get
scratched, or the rubber blades will get damaged.
In cold weather, the blades may freeze to the windshield, becoming stuck.
Operating the wipers in this condition may damage the wipers. Use the defroster
to warm the windshield, or manually clear the windshield of ice and snow before
turning on the wipers.
VEHICLE CONTROLS
Pull to
use
washer.
Intermittent time
adjustment ring
MIST
OFF
INT : Intermittent
LO : Low speed wipe
HI : High speed wipe
INT : Intermittent
ON : Continuous wipe
OFF
Washer
| 31