Yamaha Road Star Warrior 2006 Owner's Manual page 21

1. Tachometer red zone
CAUTION:
Do not operate the engine in the ta-
chometer red zone. If operated in the
red zone, the tachometer segments
will start flashing to notify the rider.
Red zone: 5000 r/min and above
Odometer and tripmeter modes
Pushing the "SELECT" button switches
the display between the odometer
mode "ODO" and the tripmeter modes
"TRIP 1" and "TRIP 2" in the following
order:
ODO → TRIP 1 → TRIP 2 → ODO
INSTRUMENT AND CONTROL FUNCTIONS
If the fuel level warning light comes on
(see page 3-2), the odometer display
will automatically change to the fuel re-
serve tripmeter mode "TRIP F" and
start counting the distance traveled
from that point. In that case, pushing
the "SELECT" button switches the dis-
play between the various tripmeter and
odometer modes in the following order:
TRIP F → TRIP 1 → TRIP 2 → ODO →
TRIP F
ECA11551
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and 90 seconds have passed.
Meter lighting control mode
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then af-
ter five seconds, release the "SE-
LECT" button.
4. Push the "RESET" button to select
the desired brightness.
5. Push the "SELECT" button to set
6. Turn the key to "OFF".
NOTE:
When adjusting the meter lighting, the
odometer display will indicate the
brightness level.
Clock mode
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
5. Push the "SELECT" button and
Self diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
3-4
the brightness level.
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.
3