Hsi (Hot Surface Indicator) - Wolf CT15I Technical & Service Manual

Component Access and Removal
I I n n d d u u c c t t i i o o n n C C o o o o k k t t o o p p
Element Removal
First, disconnect wiring to temperature sensor. (See
Figure 4.6).
NOTE: Temperature sensor is part of element. When
reinstalling element and temperature sensor assembly,
make sure temperature sensor is tucked into tabs on
element. (See Figure 4.7).
Now, lift element straight up and off mounting brackets.
Disconnect wiring to element then remove. (See Figure
4-8).
HSI (Hot Surface Indicator) Removal
Disconnect wiring at HSI. Extract screw securing HSI
to unit and remove. (See Figure 4.9).
Figure 4.8. Lift element with temperature sensor and
disconnect wiring.
NOTE: To remove rear HSI, the bracket it is attached
to will need to be removed first. (See Figure 4.10)
Figure 4.9. Front HSI (Heat Sensor Indicator).
Figure 4.6. Temperature Sensor Removal.
Figure 4.10. Rear HSI (Heat Sensor Indicator).
Figure 4.7. Position Temperature Sensor under tab.
4-4