Maintenance - Panasonic EH-NE86 Operating Instructions Manual

Maintenance

Always turn the power switch off and disconnect the
plug from the household outlet. (Except when performing
maintenance on the air outlet)
Maintaining the hair dryer
Clean the hair dryer when it gets dirty.
Clean the housing only with a soft cloth slightly dampened
with tap water or soapy tap water.
►Note
• Do not use substances such as alcohol, nail
polish remover or detergent (hand soap).
Doing so may result in malfunction or part
cracks or discoloration.
• Do not leave the appliance with hairdressing
products or cosmetics on it.
Doing so may cause deterioration of the plastic,
leading to discoloration or cracks.
Maintaining the air inlet
Clean the air inlet once a month or more.
Wipe to clean lint, hair, or
other matter from the air inlet
with a tissue or toothbrush.
►Note
• Do not press or rub with
your nails or sharp items.
Doing so may cause the air
inlet to break.
8
alcohol
polish
remover
If dust is attached to the
inside, remove it with a
vacuum cleaner.
Maintaining the air outlet
Clean the air outlet once a month or more.
Scrub to remove any dust, hair, etc. blocking the mesh.
● The hair dryer should be plugged into the household outlet
only in case of maintenance for the air outlet.
● Set the temperature selector to " " and the power switch to
" " for using cool airflow to blow away the dust, etc., as you
scrub with the toothbrush.
►Note
• During maintenance, do not block the air inlet with your
hands, etc.
• During or after maintenance of the air outlet, dust, etc. may
scatter. Ensure that the hair dryer blows no dust, etc. from
the air outlet before using. (Do not look into the air outlet.)
(Use a commercially available toothbrush.)
Maintaining the ion outlet
Clean the ion outlet about once every 6 months.
This maintenance allows the hair dryer to sustain the
generated level of ion over a long period.
● Use commercially available
cotton swabs. (We recommend
the thin cotton swabs made for
use with babies.)
● Softly insert the cotton swab
until it stops (approximately
6 mm), and turn it softly for
2 or 3 times.
Gently rub the tip of
the needle portion
Ion outlet