Table of Contents
Advertisement
Frequently asked questions
Message
The symbol lights up
on the status display
and an audible signal
also sounds.
lights up yellow on
the display and an
alarm also sounds.
lights up red in
the display and a
fault code F with
numbers may ap-
pear. An alarm
will also sound.
78
Possible cause and solution
The carbon-filter change indicator reminds you
that the carbon filter needs to be changed.
Replace the carbon filter in the holder (see "Clean-
ing and care – Replacing the carbon filters (op-
tional accessories)") and touch the symbol on
the display to confirm that you have changed the
carbon filter.
The symbol will go out on the status display.
The door alarm has been activated.
Touch and hold
onds.
The alarm will stop and the
Close the appliance door.
There is a fault.
Tap on the display to switch the alarm off.
Contact Miele Customer Service.
To report the fault, you need the fault code and also
the model identifier and serial number of your refrig-
eration appliance. You can access this information on
the display.
To do this, touch on the display.
The appliance data required will be shown on the
display.
Confirm with OK to exit the information display and
the fault code will be shown again on the display.
The refrigeration appliance can be switched off di-
rectly from the fault-message display.
There is an appliance fault: this display always has
priority over any settings which have just been se-
lected.
An appliance fault has priority over any current door
and/or temperature alarms displayed.
in the display for a few sec-
symbol will go out.
Advertisement
Table of Contents
