Table of Contents
Advertisement
DAILY USE
WARNING! Refer to Safety chapters.
ACTIVATING AND DEACTIVATING
Touch
for 1 second to activate or deactivate the
hob.
AUTOMATIC SWITCH OFF
The function deactivates the hob
automatically if:
•
all cooking zones are deactivated,
•
you do not set the heat setting after you activate
the hob,
•
you spill something or put something on the
control panel for more than 10 seconds (a pan,
a cloth, etc.). An acoustic signal sounds and the
hob deactivates. Remove the object or clean the
control panel.
•
the hob gets too hot (e.g. when a saucepan
boils dry). Let the cooking zone cool down
before you use the hob again.
•
you use incorrect cookware. The symbol
comes on and the cooking zone deactivates
automatically after 2 minutes.
•
you do not deactivate a cooking zone or change
the heat setting. After some time
and the hob deactivates.
The relation between the heat setting and the
time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
THE HEAT SETTING
To set or change the heat setting:
Touch the control bar at the correct heat setting or
move your finger along the control bar until you
reach the correct heat setting.
comes on
The hob deactivates
after
6 hours
5 hours
4 hours
1.5 hour
JOINZONE
The function operates when the pot
covers the centres of the two zones.
This function connects two left side cooking zones
and they operate as one.
First set the heat setting for one of the left side
cooking zones.
To activate the function: touch
change the heat setting touch one of the control
sensors.
To deactivate the function: touch
cooking zones operate independently.
When you use only one cooking zone of the pair we
recommend that you use the rear cooking zone.
Also when you use large cookware we recommend
that you put it near to the rear cooking zone.
AUTOMATIC HEAT UP
Activate this function to get a desired heat setting
in a shorter time. When it is on, the zone operates
on the highest setting in the beginning and then
continues to cook at the desired heating setting.
To activate the function the cooking
zone must be cold.
To activate the function for a cooking zone:
touch
(
comes on). Immediately touch a
desired heat setting. After 3 seconds
To deactivate the function: change the heat
setting.
POWERBOOST
This function makes more power available to the
induction cooking zones. The function can be
activated for the induction cooking zone only for a
limited period of time. After this time the induction
cooking zone automatically sets back to the highest
heat setting.
Refer to "Technical data" chapter.
. To set or
. The
comes on.
9
Advertisement
Table of Contents
