Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZAF20
Summary of Contents for Zanussi ZAF20
-
Page 2: Technical Data
Total strength: 2500 W Voltage tension: 230 V 50 Hz MANUFACTURER: ZANUSSI ELETTRODOMESTICI S.p.A. Viale Bologna 298 47100 FORLÌ (Italy) This appliance conforms to the following EEC Directives: - 72/23 EEC - 90/683 EEC - 93/68 EEC - 89/336 EEC... - Page 3 IMPORTANT NOTICES AND ADVICE RELATING TO ELECTRIC HOBS It is important that this instruction brochure be kept together with the appliance for future consultation. If the appliance is sold or transferred to another person, ascertain that the brochure is also given, in order that the new owner be aware of the correct use of the apparatus and the rela- tive instructions.
- Page 4 INSTRUCTIONS FOR USER All operations relating to the connection of the hob must be carried out by qualified personnel, according to the regulations in force. Specific instructions are contained in the notices reserved for the installer. smaller than that of the plate (figure 2); do not allow liquids to boil over onto the plate;...
-
Page 5: Maintenance
MAINTENANCE Clean the control panel with a damp cloth, do not use clean it regularly. Naturally, before cleaning the abrasive products. The knobs can be removed by lif- plates, allow them to cool. ting to facilitate cleaning. Do not acquire the bad habit of wiping over the plates The enamelled part of the hob can be cleaned with with a damp cloth whilst they are still hot. - Page 6 REPLACEMENT OF THE VOLTAGE CABLE The connection of the voltage cable to the appliance’s terminal box is of type “Y” which signifies that its replacement requires the specific equipment of a technician. If the replacement of the cable is necessary, use only cables type H 05 VV H2-F O T 105;...
-
Page 7: Installation And Assembly
INSTALLATION IN A KITCHEN UNIT This hob can be inserted in a fitted kitchen unit with a depth of between 550 and 600 mm and having suitable characteristics. Dimensions (fig. 5) The fixture of the hob to the unit must be carried out as follows: Position the relevant sealings, supplied, on the edge of the opening predisposed for installation, taking... - Page 8 Possibilities for insertion Kitchen unit with door 550 min. The unit which will receive the hob should be designed as illustrated in figure 8. The panel under the hob should be easily removable to permit the blocking and unblocking of the hob for technical assistance.
- Page 9 Figures ll-l2 illustrate two possible solutions. The electrical fittings of the oven and the hob must be carried out separately and remain accessible. 50 cm 120 cm 360 cm 180 cm FO 2104 FO 2105 Fig. 11 Fig. 12...