Adjusting The Tracking; Checking The Tire Pressure - Toro 74960 Operator's Manual

1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area, and move the
motion-control levers to the N
position.
3. Move the throttle midway between F
S .
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until
the machine tracks straight
Figure 63
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL LOCK
AST
(Figure 64).
7. If it tracks to the left, loosen the bolts and adjust
the right stop plate rearward on the right T-slot
until the machine tracks straight
8. Tighten the stop plate
g008943
1. Control lever
2. Bolt

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
and
50
(Figure 64).
Figure 64
Left control lever shown
3. Stop plate
comes first)
(Figure 64).
g027340