Table of Contents
Advertisement
1. Deck-lift pedal
2. Height-of-cut pin
6.
Insert the height-adjustment pin into the 7.6 cm
(3 inches) cutting-height location.
7.
Release the transport lock and allow the deck to
lower to the cutting height.
8.
Raise the discharge chute.
9.
On both sides of the deck, measure from the
level surface to the front tip of the blade (Postion
A) as shown in
Figure
Note:
The measurement should read 7.6 mm
(3 inches)
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10.
Fine-tune the adjustment nut on the front deck
lift assembly by turning it
Figure 90
3. Transport lock
91.
Figure 91
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
92).
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn it
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
g008965
1. Adjustment nut
2. Jam nut
11.
To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure
93).
g009196
64
Figure 92
3. Rear deck adjustment
4. Front deck adjustment
g027344
Advertisement
Table of Contents
