Dynamic Weighing - OHAUS Catapult 1000 Series Instruction Manual

Catapult 1000 Series Scales
NET weight. When removing both the sample and container from the scale, a
negative value may be displayed. Zero the scale again before subsequent usage.
NOTE: The ON/ZERO
displayed values are within +2% of full capacity. Above 2%, the range is limited to
full capacity by subtraction.
3.3 Changing Units of Measure
Cal
Press the UNITS
3.4 Auto Shut-Off
To extend battery life, the scale will automatically turn off after approximately four
minutes of inactivity. This feature is only active during battery operation.

3.5 Dynamic Weighing

With the platform empty, short press the UNITS
to cycle through the units. Dynamic mode is active when
the indicator • is flashing.
Place a mass on the platform. The scale will show "-A-".
NOTE: If using a container, press
weight and return to zero.
With a mass on the platform or container, a short press of
Cal
UNITS will start the averaging countdown from 5
seconds.
The averaged weight is then displayed. The indicator •
stops flashing when the process is complete.
The display will hold until a button is pressed.
To repeat the process press UNITS
platform or container.
To Exit, remove the mass from the platform or container and
Cal
press UNITS .
Off
button will perform a true zero setting function when
button to display the next available measuring unit.
ON/ZERO
Cal
Cal
button
Off
to tare the
with a mass on the
EN-5