Riello RG3D L Installation, Use And Maintenance Instructions page 55

1. BURNER DESCRIPTION
Two stage light oil burner.
Burner with CE marking in conformity with EEC Directives: EMC 89/336/EEC, Low Voltage 73/23/EEC,
Machines 98/37/EEC and Efficiency 92/42/EEC.
CE Certification No.: 0036 0348/04 (type 380T1), 0036 0298/00 (type 394T1), 0036 0348/04 (type 397T1),
as 92/42/EEC.
IlThe burner meets protection level of IP X0D (IP 40) as EN 60529.
The burner is approved for intermittent operation as per standard EN 267.
1 – Pump with pressure reducer
2 – Blast tube
3 – Control box
4 – Reset button with lock-out lamp
5 – Flange with insulating gasket
6 – 2 nd stage air damper adjustment assembly
1.1 BURNER EQUIPMENT
Flange with insulating gasket . . . . . . No. 1
Screw and nuts for flange . . . . . . . . No. 1
4 pin plug . . . . . . . . . . . . . . . . . . . . No. 1
1.2 ACCESSORIES
SOFTWARE DIAGNOSTIC KIT
A special kit is available that, by an optical link to a PC, shows the burner life together with operating hours, type
and number of failures, serial number, etc.
To visualise the diagnostics proceed as follows:
Connect the kit supplied separately to the control box socket.
Reading of the information begins when the software programme included in the kit starts.
REMOTE RESET KIT
The burner has a remote reset kit (RS) consisting of a connection and a push-button operating at a dis-
tance of 20 metres max.
In order to install it remove the protective lock-out installed at the factory and insert the lock-out supplied
with the burner (see electrical diagram on page 6).
3363
Fig. 1
2
5
D4682
4
3
7
12
1
7 – Nozzle holder assembly
8 – Flame detector
9 – Hydraulic jack
10 – 4 pole socket
11 – 2 nd stage valve
12 – 1 st stage valve
Screw and nuts for flange to be fixed to boiler . . . .No. 4
Flexible oil pipes with nipples. . . . . . . . . . . . . . . . .No. 2
Remote reset connection . . . . . . . . . . . . . . . . . . . .No. 1
2
GB
6
8
10
9
11